Connect the supplied AC adapter to the power input terminal of this. Set the router's WPS to valid, and perform the following steps within. For details, refer to the operating instructions of your router.
It may take about 2 minutes to establish a WPS connection. For details on installation and usage, refer to the Application Guide. The camera s connected to the local network is detected and its list is. In this case, click "Allow. In this case, invalidate the corresponding. Windows 8, disable Windows Firewall. For details, refer to the Application Guide.
Before installing SNC toolbox, log in to your computer as Administrator. When you display the camera viewer for the first time, "Security Warning" is. Click [Yes], and install ActiveX Control.
Before installing ActiveX Control, log in to your computer as Administrator. If installation of ActiveX is prohibited by the pop-up block function of Internet. Explorer or pop-up blocking software, installation of ActiveX is not possible. If video images are not displayed correctly, set the security level of Internet.
Explorer to [Medium] or lower. For details, see the User's Guide. If your. Previous Page. Next Page. Page 2: Troubleshooting Connecting to a wired network Additional Informations Troubleshooting Initializing this unit Preparing the camera Confirm radio signal status If you experience any difficulties while using this guide, check the following.
With the unit turned on, press the reset switch with a ball-point pen, etc. The settings will return to their factory defaults. Print page 1 Print document 2 pages. Rename the bookmark. Delete bookmark? Setting a single event recording The setting to record a video for a specified period when the presence sensor has reacted is performed here. Page 28 3. Setting a multiple event recording The setting for setting multiple event conditions and recording a video for a specified period when the conditions are met is performed here.
Open Event condition Action input, set as a desired condition, Page 30 3. Perform the setting for conditions to be set from above tabs. Perform detailed setting of the set condition from each tab Always set the event conditions other than the presence sensor. Page 31 5. Set to [Event condition 1] Click after setting Setting is completed if the setting for [Edge Storage movie] is changed to [Event condition 1] after clicking OK.
Click Search panel List panel Control panel Page 33 Specify the search period in the [Search] panel and click Search. Specify the search period. Select the video to play back after the search result is displayed in the [List] panel, and click playback in the [Control] panel. Page 34 Select the video to save from the [List] panel and click Export. Select the list to record Click 2.
A wizard for exporting is displayed. When completed, click Close. The saved video file is displayed by clicking on the open file in the [List] panel. Page 35 Select the video in the [List] panel and click Delete. Select the video to delete Click 2.
Enter the administrator user name and password in the [Authentication] window and click OK. Enter Click 3. To forcefully light up the white LED This is a function to forcefully light up the white LED regardless of the presence sensor or the ambient brightness of the environment. Please note that the procedure is different depending on the software version of the camera.
To confirm the response of the presence sensor 1. Click Click 3. Click Superimpose. Place a check mark in the check box and set [Type] to [Event].
Set [Events displayed] to [Presence sensor] and click OK. Set to [Presence sensor] Click 6.
0コメント